Silvercrest SNAW 1000 D2 - Displaying Added Measured Values; Deleting Measured Values

■ 10
│
GB
│
CY
SNAW 1000 D2
Deleting measured values
Press the MC button 5 if you wish to delete the saved measured values.
The display of the last weighing number goes out and all measured values are
deleted.
Saving personal codes
You can enter the nutritional and energy values for further foods, assign a code
to these and save them in memory entries 800–999 (empty at delivery). The
values you enter each refer to 100 g of food.
You can find the nutritional values of foods on their individual packaging or in
specialist literature.
Proceed as follows:
1) Press the ON/OFF button 9 to switch on the scales.
The display 3 shows all of the indicators for about 2 seconds.
2) Press the MR button 6 and the UNIT button 8 at the same time for about
3 seconds until “Code 800” flashes on the food code display t.
3) Use the number buttons 4 to enter a code between 800 and 999 that you
can use to save the nutritional and energy values for a new food.
4) Confirm the entry of the code number by pressing the MR button 6. The
new code number is now permanently displayed and PROT flashes on the
nutrition/energy displays e. Enter the value for the protein content in grams
(per 100 g food) (to two decimal places) using the number buttons 4.
5) Confirm the entry by pressing the MR button 6. FAT flashes on the nutrition/
energy displays e. Enter the value for the fat content in grams (per 100 g
food) (to two decimal places) using the number buttons 4.
6) Confirm the entry by pressing the MR button 6. CARB flashes on the nutri-
tion/energy displays e. Enter the value for the carbohydrate content in
grams (per 100 g food) (to one decimal place) using the number buttons
4.
7) Confirm the entry by pressing the MR button 6. KCAL flashes on the nutrition/
energy displays e. Enter the value for the kilocalories (per 100 g food)
using the number buttons 4.
8) Confirm the entry by pressing the MR button 6. CHOL flashes on the nutrition/
energy displays e. Enter the value for the cholesterol content in milligrams
(per 100 g food) using the number buttons 4.
9) Press the MR button 6 to complete your entry of the nutritional and energy
values.