Silvercrest SRH 5 B2 - Handling and Operation; Powering On;Off and Mode Switching

■ 46 │ GB
│
IE
SRH 5 B2
Handling and operation
Switching the device on/off
NOTE
► The DAB+ station list is automatically created or updated the first time
the device is switched on from standby mode using the button 2. The
display
1 now shows the message Scanning.... Depending on the quality
of the DAB+ radio reception, this process can take up to several minutes.
► When you switch on the device from standby mode with the
button 2,
the device will be in the last selected mode (DAB, FM, Bluetooth
®
or
AUX IN).
♦ Briefly press the
button 2 to switch on the device. The device automati-
cally starts in DAB+ radio mode the first time it is switched on.
♦ Briefly press the SOURCE /
button 3 to switch between DAB+, FM
radio operation, Bluetooth
®
or AUX IN mode.
♦ Press the
button 2 again to switch off the device and put it into standby
mode.
Adjusting the volume
♦ Turn the VOLUME | ENTER / SCAN dial6 clockwise to increase
the volume.
♦ Turn the VOLUME |
ENTER / SCAN dial6 anticlockwise to reduce
the volume.
NOTE
► The display
1 shows the volume as a bar for a few seconds after pressing
the VOLUME |
ENTER / SCAN dial6.
Radio operation
You can use the radio to receive DAB+ and FM radio stations. You can store up
to 40 preset DAB+ and FM radio stations each.
NOTE
► When the device is first used, it starts in DAB+ radio mode and the station
list of the available DAB+ radio stations is created automatically.
The display
1 now shows the message Scanning....