Silvercrest SRH 5 B2 - External Audio and Headphones; Connecting External Devices (AUX IN)

GB
│
IE │ 55 ■
SRH 5 B2
Connecting external playback devices (AUX IN mode)
In AUX IN mode, you can connect external playback devices such as a smart-
phone or an MP3 player to use them as the playback source for the radio.
NOTE
► Switch the radio and the external playback device off before connecting
them. Note also the operating instructions for the device that you want to
connect to the radio.
♦ Connect the external playback device to the AUX IN socket
w of the radio
using the supplied AUX cable.
♦ Briefly press the
button2 to switch on the radio.
♦ Briefly press the SOURCE/
button 3 (several times if necessary) until
AUX IN appears on the display
1.
♦ Turn on the external playback device and start playback.
♦ Afterwards, set the desired volume using the VOLUME |
ENTER /
SCAN dial
6 on the radio. Alternatively, you can increase the volume on
the external playback device.
♦ To exit AUX IN mode, turn off the radio and the external playback device.
Remove the AUX cable
from the AUX IN socket w of the radio.
Alternatively, you can press the SOURCE/
button 3 to switch directly
from AUX IN mode to radio mode or Bluetooth
®
mode.
Connecting headphones
♦ Turn the VOLUME | ENTER / SCAN dial6 anticlockwise to the
lowest volume level.
♦ Plug the jack plug of the headphones into the headphone socket
e
on the rear of the device. Sound playback now takes place only via the
connected headphones.
♦ Set the desired volume using the VOLUME |
ENTER / SCAN dial6.