Silvercrest SSJ 300 B3 - Page 36

34
GB
Insert the screen assembly6
6. Place the screen assembly6 into the
working container8 so that the
arrow
 points to the closed lock
symbol .
Check: the screen assembly sits in its
position and can only be moved slight-
ly back and forth.
Insert the auger5
7. Slide the auger5 into the screen as-
sembly6 while turning it clockwise
and at the same time push it down
slightly. Finally press the auger5 down
completely.
NOTE: if the auger5 is not inserted deep
enough, the lid4 will not close properly.
Mount the lid4
8. Place the lid4 on the working contain-
er8 so that the point symbol
• points
to the opened lock symbol .
6
8
5
6
4
8
__352263_2007_Slow_Juicer_B8.book Seite 34 Montag, 7. Dezember 2020 4:49 16