Silvercrest SSWR C2 - Cleaning and Care; Disposal

24 GB/IE/NI
Fault Possible cause Solution
The product does not
automatically start cleaning at
the scheduled time.
The schedule entries were not
stored.
Set the schedule again and
store the entries (see “Setting a
vacuuming schedule“).
The schedule entries were
deleted when resetting
the product or changing
the batteries in the remote
control
[].
Switch the product on and
set the schedule again
(see “Setting a vacuuming
schedule“).
The product is switched off. Switch the product on.
The battery level is low.
Never switch off the product.
Always park the product in
the charging dock
[5] so that
it is always fully charged and
ready to use.
The product cannot move.
Switch the product off. Inspect
and clean the product. Remove
any foreign objects (see
“Cleaning and care“).
NOTE: If the suggested solutions do not
solve the problem, proceed as follows:
o Reset the product by switching it off and
back on again with
[2].
o If the product still does not work after
this reset, contact the Service Centre (see
“Service”).
 Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics/20–22: paper and
fibreboard/80–98: composite
materials.
Product:
Contact your local refuse disposal
authority for more details of how to
dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when
it has reached the end of its useful
life and not in the household waste.
Information on collection points and
their opening hours can be obtained
from your local authority.
Faulty or used batteries/rechargeable batteries
must be recycled. Return the batteries/
rechargeable batteries and/or the product to the
available collection points.