Stop watch function
The stop watch function is only available when the radio is switched off.
• Press and hold down the
PAGE button for around 2 seconds, the screen
shows 0.00 0 U.
• Press
SNOOZE to start the stop watch. The maximum time for the stop watch
is 39 minutes and 59 seconds. If the stopwatch exceeds the maximum
time, the indicator 39:59.0 appears and flashes in the display.
• During time measurement, it can be stopped by pressing
SNOOZE.
• Pressing
SNOOZE again restarts the stop watch.
• Hold down
SNOOZE to reset the stop watch.
• Leave the stop watch by pressing
PAGE.
Countdown function
The countdown function is only available when the radio is switched off.
Set and save countdown
• Press and hold down the MEMORY SCAN button for around 2 seconds,
the screen shows 0.00 D. The D blinks.
• Press the
UP or DOWN button to set the desired time.
5 countdown times are preset on the memory buttons and you can open
these directly using the corresponding memory button:
Button
M.0/5 5:00 Button M.1/6 10:00
Button
M.2/7 15:00 Button M.3/8 20:00
Button
M.4/9 25:00
• Press the
MEM button to save the set time, the memory space indicator
MEM flashes on the screen. Now use the M.0/5–M.4/9 buttons to select
a memory space; when you press the relevant memory key the time is
saved in this memory space and the time previously stored there
overwritten. Pressing the
MEM button again will save the set time.
• When the
MEMORY SCAN button is pressed again you leave the
countdown mode.
- 21 -
GB/CY
To Next Page
Loading...
