Silverline 631320 - Troubleshooting Common Issues; No Power or Trigger Function; Sander Pulls to the Side; Squealing or Power Loss

GB
8
Troubleshooting
Problem Possible cause Solution
NofunctionwhenOn/OffTrigger(7)
is operated
Nopower Checkpowersupply
Defective On/Off Trigger Replace the On/Off Trigger at an authorised Silverline service centre
Sander pulls to the side
during operation
Off-centre sanding belt
AdjusttheBeltTrackingAdjuster(6)toalignthebelt.Ifproblempersists,retthebeltas
instructedin‘Fittingasandingbelt’
Loose sanding belt
EnsuretheBeltReleaseLever(10)issecurelyclosed.Ifproblempersists,retthebeltas
instructedin‘Fittingasandingbelt’
‘Squealing’soundorintermittentloss
ofpowerwhilstsanding
Drivebeltisworn Replacethedrivebeltasinstructedin‘Drivebeltreplacement’
Belt sander running despite not
touching the On/Off Trigger
LockOnButton(2)activated Tostopthemachine,squeezeandreleasetheOn/OffTrigger
631320_Manual.indd 8 23/05/2017 17:24