Silverline 793759 - Troubleshooting

EN
8
Problem Possible Cause Solution
Tool operating slowly
Pressure incorrect Setthecorrectairpressureaccordingtothespecication
Dirt within the mechanism Repeat the ‘Daily maintenance procedure’ several times to clear the dirt
Air blockage Operate tool in short bursts to clear blockage
Air leak Checkallttingsandhoseforairleaksandcorrectissuebyre-
tightening, using PTFE tape or replacing
Blockageingauzemeshlter RemoveQuickConnector(4)andcleanmeshlter
Tool seized
Dirt or rust in mechanism Try ‘Tool operating slowly’ solutions
Dirt or rust in mechanism Tap tool gently with a soft mallet
Dirt or rust in mechanism Free mechanism by rotating drive manually when disconnected from
air line
Tool will not stop after Trigger (6)
is fully released
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
793759_OwnerManual.indd 8793759_OwnerManual.indd 8 19/04/2024 08:5019/04/2024 08:50