Page 6 / 26
1.5 Residual Hazards
During operation of the systems, further hazards may arise that can be
prevented through safety-conscious working procedures.
Danger !
Touching live parts is potentially fatal.
Observe the warning notices fitted.
Do not remove any covers on the control cabinet.
Work on the electrical fittings may only be carried out by
authorised electrical specialists.
Caution !
Parts of the blower unit heat up during operation.
1.6 Requirements on personnel and duty of care
Work on the system may only be carried out by reliable, trained and fully
inducted personnel.
Only authorised personnel may work at the machine.
Never allow machine components to be operated by personnel who are under
the influence of sedatives, or who for health reasons are not in a fit state to
operate them.
Any personnel who are under training, induction, or who are involved in general
training, may only work at the machine under the constant supervision of a
qualified and experienced person.
Work on the electrical fittings of the individual machines may only be
undertaken by authorised electrical specialists and in compliance with the
operating manual of the electrical fittings supplier.
Only fully inducted personnel with special knowledge and experience of
pneumatics may work on compressed air devices.
Caution !
The Operating Manual must always be available at the place of use.
The operating personnel must know where it is kept.
To Next Page
Loading...