7
To setup MIDI channel on Out Port 1, press the C key, as shown below. This will flash the key of C, indicating your
setting the MIDI Channel for Out Port 1. Turn the “Dial” clockwise to the desired MIDI Channel and press the Dial or
the key of C for confirmation. Keep in mind that this MIDI channel chosen here must correspond to the instrument’s
Global MIDI Channel. At this point, the 3 keys, C, D, and E will start flashing again
indicating to the user that the device is back at the Submenu.
To setup MIDI Channel for Out Port 2, press the key of D as shown below. The
key of D will start flashing indicating its ready to set the MIDI Channel for Out
Port 2. Turn the “Dial” clockwise to the desired MIDI Channel and press the Dial
or the key of D for confirmation. At this point, the 3 keys, C, D, and E will start
flashing again indicating to the user that the device is back at the Submenu.
To setup MIDI channel on Out Port 3, press the E key as shown below. This will
flash the key of E, indicating your setting the MIDI Channel for Out Port 3. Turn
the “Dial” clockwise to the desired MIDI Channel and press the Dial or the key of
E for confirmation. At this point, the 3 keys, C, D, and E will start flashing again
indicating to the user that the device is back at the Submenu.
This completes the setup of MIDI channels for all 3 ports.
Note: The user is not required to setup all 3 MIDI ports. Only setup the ports that are being used. I.e. if only MIDI Out
Ports 1 and 2 are used, then only setup 1 and 2, setting Out Port 3 can be skipped.
To Next Page
Loading...
Need help?
General