SimPal-G400 4G Alarm Camera User Manual
52
socket, it can remote turn on/off socket power, make socket work in schedule control,
thermostat control etc functions. Detail SMS command and function refer slave socket
user manual.
7. Reset to factory settings
You can reset the camera to factory setting if forgot the master number or camera do not
work normally.
After reset factory setting, camera will delete all settings.
Method 1: Reset by pressing setting button
Power on camera and wait until it work in standby mode.
Remove the battery cover; the setting button is near the DC power connector.
Keep pressing the setting button for 5 seconds, camera will beep ring.
Then the camera reset to factory setting successfully.
Method 2: Reset by SMS command
Master sends following SMS message to:
Reset the camera: #08#1234#
To Next Page
Loading...