Need help?Do you have a question about the Simplex 4098-9685 and is the answer not in the manual?
General| Brand | Simplex |
|---|---|
| Model | 4098-9685 |
| Category | Accessories |
| Language | English |
Details electrical and static electricity hazards and precautions during installation and servicing.
Explains limitations and proper use of duct smoke detectors/sensors as secondary devices.
Specifies connection requirements for Canadian installations with older ULC standards.
Provides an overview of Simplex duct detector/sensor configurations and their basic functions.
Explains the meaning of LED indicators on different duct detector/sensor models during operation.
Details the supervised control circuits for remote relays used with specific duct detector/sensor models.
Explains the importance of unique sensor addressing for system reporting and custom labeling.
Provides step-by-step instructions for setting duct sensor addresses on the 2120 CDT system.
Details how to set duct sensor addresses using System Point Summaries for specific Simplex panels.
Introduces electrical requirements and power/current specifications for addressable duct sensors.
Outlines the maximum quantity of duct sensors supported per circuit on various Simplex systems.
Details electrical specifications for 4098-9685 (two-wire) and 4098-9688 (two-wire with relay).
Provides electrical specifications for the 4098-9686 four-wire duct detector with remote relay control.
Lists compatibility and maximum device quantities for two-wire duct detectors with various system models.
Describes the 2098-9808 and 4098-9830 accessories for visual alarm indication.
Details the 2098-9806 and 4098-9834 accessories for alarm indication and control functions.
Explains the 4098-9835 accessory for power status, alarm indication, and control functions.
Outlines essential checks and considerations before installing duct detector/sensors.
Provides guidelines for selecting optimal locations within ductwork for detector/sensor efficiency.
Covers placement rules for branch lines, filters, serviceability, and ahead of mixing areas.
Details the steps for mounting the duct housing using a template and drilling holes.
Guides on choosing and installing inlet tubes based on duct width and airflow direction.
Covers securing the housing, installing inlet tubes with retainers, and sealing openings.
Details the process for installing the exhaust tube and securing its retainer.
Explains conduit routing and wire connections to the duct housing assembly.
Describes how to install optional accessories like remote indicators and key switches into outlet boxes.
Step-by-step guide for removing and replacing detector/sensor heads from their bases.
Details methods for testing detector functionality and performing periodic air velocity checks.
Explains how to perform magnetic tests for sensors and detectors, including LED responses.
Describes detector LED behavior (Normal, Sensitive, Non-Functional) during magnetic tests.
Outlines the NFPA-required annual testing method using smoke aerosol.
Details basic unit testing procedures for detectors/sensors and their operation with remote indicators.
Explains testing procedures when using specific accessory options like key switches.
Describes how to measure air differential pressure across the detector/sensor for proper operation.
Provides guidance on periodic checks and cleaning of sampling tube holes and air entry areas.
To Next Page
