Simplex POWERSTAR 110 KW - Page 19

Page
17
Reference
Number
Explanaon
1
The “Fan” switch will turn the fan and unit on.
2
The “Load” switch will apply the set load to the tesng source.
3
The “Vavg” is the average voltage of the load.
4
This secon will designate the phase in which the load bank is running. It can be in 1Ph
(single phase) or 3Ph (3-phase).
5
The “Available” secon is how much KW is available for use.
6
The “Running” is the amount of KW load bank has aempted to apply.
7
The “Normal Operaon” secon will remain normal unless an error appears. Touch-
ing here, “ERR” (Reference Number 10), or F1 will access the errors and allow you to
address the issues.
8
The “Entry” value is the value entered that you desire for the load. When touched, a
number pad will appear for entering values.
9
The “Metered” secon is the amount of KW the load bank has applied as read from
the on-board digital meter.
10
The “ERR” selecon will load the error tab for the HMI. If any errors are acve, then
this tab will show what is causing the errors.
11 & 12
The JG+ and JG- values are abbreviaons for “Jog Up” and “Jog Down,” respecvely.
These will increase or decrease the KW entry by a value set in the setup (See Refer-
ence 14).
13
The “MTR” (Meter) buon will display the metering screen.
14
The “SHF” (Shi) buon will reveal newer funcons of “AJG” and “SET” on the boom
of the screen where the funcon buons are.
15
The “AJG” (Auto-Jog) buon will allow you to set the Auto-Jog funcons. By using a
minimum and maximum value as well as seng the steps and duraon to go from the
minimum to the maximum, the auto-jog will run in a loop unl stopped.
16
The “SET” buon will load the setup menu. Please see “6.6.1 Setup Informaon” on
page 20 for more informaon on the setup menu.
Table 2 Screen Denitions