Simplicity 1692609 - User Manual

How to use this file...(Labels & Miscellaneous Documents)
————————————————————————————————————————————–––
Instructions for
Print Vendors (Paper Manuals)
Paper: * Various...
Press: * Various...
Bindery: * Various...
General: * This instruction page is NOT part of the document and must NOT be printed.
• Pages labeled with the text “THIS PAGE INTENTIONALLY BLANK” are placement pages ONLY,
and should NOT be printed.
• THIS document will most likely be a unique piece -- either a label or certificate or
other such miscellaneous format.
• EXACT specifications on the print & job specs should already be known to
you. In you are uncertain of what these specifications are, please contact
Simplicity Technical Publications.
• (Note: We will do our best to answer your questions concerning this job, but may need to transfer
you to another department within our company for additional specifications and job
requirements).
————————————————————————————————————————————–––
If you have further questions on how to utilize this file, please contact
Simplicity Technical Publications Department at (262) 284-8647.

Simplicity 1692609 Specifications

General

Type	Lawn Tractor
Fuel	Gasoline
Transmission	Hydrostatic
Engine	Briggs & Stratton
Engine Type	Single-cylinder OHV
Horsepower	16 hp
Tire Size - Front	15x6-6
Tire Size - Rear	20x8-8
Cutting Height	1.5 inches

Summary

Neutral Adjustments

Transmission Purging

Section 1. Commercial Front-Cut Rider with Dual Eaton Model 7 Hydrostatic

Wheel-Steer Adjustments

Travel Stop Adjustments

Section 2. Large-Frame Tractors with Shaft Drive - Sundstrand Model 15 Hydrostatic

Section 3. Large-Frame Tractors with Belt Driven - Sundstrand Model 15 Hydrostatic

Section 4. Tractors with Tuff Torq K215-A & HydroGear (Sundstrand) Hydrostatic, BDU-21 L

Neutral Adjustment (Early Model Only)

Adjusting the speed control lever for neutral positioning on early models.

Late Models - Early Models with 1686602 kit installed

Neutral adjustment procedure for specific late/modified models.

Section 5. Tractors with Eaton 850 Transaxle

Section 6. Tractors with Tuff Torq K60 Hydrostatic Transaxle

Section 7. Lawn Tractors with Eaton 750 or 751 Hydrostatic Transaxle

Neutral Adjustment - (Linkage with two ball joints)

Adjusting linkage for neutral position on models with two ball joints.

Neutral Adjustment - (Linkage with one ball joint)

Section 7. Lawn Tractors with HydroGear 310 - 0500 Transaxle (With Hand Control)

Return-to-Neutral Adjustment

Section 7. Lawn Tractors with HydroGear 318-0500;322-0500;322-0650 Transaxle (With Foot Control)

Section 8. Lawn Tractors with Eaton Model 7 Hydrostatic & Peerless 1300 Series Transaxle

Section 9. Later Model Front-Cut Rider with Eaton Model 7 Hydrostatic

Section 10. Early Model Front-Cut Rider with Eaton Model 7 Hydrostatic

Section 11. Mid-Engine Riding Mowers with HydroGear 311-0500

Neutral Adjustment

Adjusting hydro control rod for correct neutral positioning.

Return to Neutral Adjustment