Simplicity 560 - Inspect the Battery

Figure 8. Lubricate Ring Gear And
Pinion Gear While Rotating Spout.
Normal Care
INSPECT THE BATTERY
(If Equipped)
WARNING
When removing or installing battery
cables, always disconnect the negative
cable first and reconnect it last to avoid
electrical shock and to avoid causing
sparks.
Battery cables and terminals should be kept
clean and free of corrosion. Baking soda and
water can be used to clean the battery,
compartment, and cables. The terminals and
clamps can be cleaned with a wire brush and
coated with petroleum jelly to inhibit cor¬
rosion. If water can be added to the battery,
the fluid should be kept above the plates. If
the battery loses its charge, see your dealer to
recharge or replace it.
Figure 9. Typical Battery Installation
(Shown with cover removed)
WARNING
Battery acid causes severe burns and is
flammable. Keep flames and sparks away
from battery. Avoid contact with skin.
13