Simpson 2 Series - Page 22

20
Operating Instructions
CONTACTS
AND
SWITCH
POSITIONS
FOR
OUTPUT
Set
the
range
selector
switch
at
the
desired
range
posi-
tion.
These
are
marked
2.5
V.,
10
V.,
50
V.,
and
250
V.
Connect
the
black
test
lead
to
the
grounded
side
of
the
circuit
to
be
measured,
and
the
red
test
lead
to
the
"hot"
side.
i
Turn on the power in the circuit. Read the output vol-
tage on the A.C. voltage arcs of the dial.
For the 2.5 V. range, read the value directly on the
special arc marked 2.5 V.A.C. ONLY.
For the 10 V., 50 V., and 250 V. ranges, use the red
arc
marked
A.C.,
and
use
the
red
figures
directly
below the arc.
Turn off the power in the circuit before disconnecting
the leads.