Simpson 460 4 Series - Page 19

Installation
quoted. This charge will not be exceeded without prior
approval.
2.6 INSTALLATION
2.6.1 The Instrument may be set horizontally on its four rubber
feet or vertically on its back and operated in either position. The
Instrument can also be set at an inclined angle by positioning the
8-position carrying handle under the unit. To set the Instrument
at a desirable viewing angle, use the following procedure:
a. Pull out both knobs on sides of Instrument.
b. Rotate handle to one of eight positions.
c. Push both knobs into a locking position.
2.7 CARE
WARNING
Do not attempt to clean this Instrument with the test
leads connected to a power source or when it is con-
nected to the AC powerline.
2.7.1 Immediately clean all spilled materials from the Instrument
and wipe dry. If necessary, moisten a cloth with soap and water
to clean plastic surfaces.
2.7.2 Do not allow the battery to fully discharge. A completely
discharged battery generally becomes inoperative and a replace-
ment will be necessary. Check the battery voltage according to
paragraph 4.3.2.
2.7.3 Whenever possible, avoid exposure or usage in areas which
are subject to temperature and humidity extremes, vibration, me-
2-3