Configuration and Setup
20222147A 73
• The Installation Settings are global except for display units
and language, enabling settings to be distributed to all control
units in the system.
4.3 Installation Menu
The Installation Menu is
presented on the autopilot
display by pressing and holding
the NAV/WIND/SETUP button
for 5 seconds.
Note ! The INSTALLATION MENU is different from the USER SETUP
MENU. Refer to the flow diagram on the next page for a
pictorial view of the Installation Menu.
Navigate through the Installation Menu as follows:
• Answer YES to a question by rotating the course knob
clockwise.
• Answer NO to a question or proceed to the next menu item by
pressing the STBD button.
• Return to the previous menu item by pressing the PORT
button.
• Change the selected item by rotating the course knob in either
direction.
• Exit the Installation Menu by pressing STBY, AUTO, or
NAV WIND buttons.
When using the Installation Menu, refer to the diagram
"Installation Menu Flow Chart" on next page.
Note ! You may proceed through all items in the installation menu by
continuing pressing the STBD button.
To Next Page
Loading...
