Sea trial
A seatrial can only be performed after the dockside settings are
completed.
Note: The seatrial must always be performed in calm
conditions, in open waters and at a safe distance from other
traffic!
Compass setup
To achieve the best possible performance, the compass should be
calibrated, and any offsets should be compensated for.
The setup needs to be done from an appropriate display unit.
Depending on the unit, access to the compass setup is available
from the compass’s device dialog, or from a dedicated Calibration
option in the unit’s Settings menu.
Device dialog, MFDs
3
16
Sea trial | NAC-2/NAC-3 Commissioning Manual
Reset autopilot computer, AP44
The first time the autopilot computer is started after reset, it will run
through the automatic setup-procedure.
Note: Unless you need to clear all values set during the
installation set-up procedure, you should not perform a reset of
the autopilot computer.
Maintenance | NAC-2/NAC-3 Commissioning Manual
33
To Next Page
Loading...
