To Next Page
A
ahunterAug 16, 2025
What to do if there is no picture on my Simrad GPS display screen?
- BbrogersAug 16, 2025
First, try pressing the [PWR] key on the keypad. If that doesn't work, replace the fuse, ensuring you use only type F6.3A.
What to do if there is no picture on my Simrad GPS display screen?
First, try pressing the [PWR] key on the keypad. If that doesn't work, replace the fuse, ensuring you use only type F6.3A.
Why is my Simrad CP34 GPS data deleted after turning the unit off and on?
If all data is deleted after turning your Simrad GPS unit off and on, the internal battery likely needs replacement. This should be done by an authorized dealer, as the expected lifetime of the battery is a minimum of 5 years.
What to do if my Simrad CP34 has no normal picture or key operation?
If your Simrad GPS shows no normal picture or key operation, try the following steps: 1. Turn the unit off and then on again. 2. Disconnect the power and then reconnect it. 3. Remove the C-MAP chart, as it may be defective.
What to do if the picture on my Simrad CP34 display is too dark or bright?
If the picture on your Simrad GPS display screen is too dark or too bright, press [PWR] to adjust the light, and then press [ENT].
Why is my Simrad CP34 screen update extremely slow?
If your Simrad GPS screen update is extremely slow, turn off ‘Course line’ for each stored route and turn off ‘Display track’.
What to do if my Simrad CP34 has no GPS position update?
If your Simrad GPS is not updating its position, try replacing the antenna or the cable.
What to do if Simrad CP34 GPS has no GPS position update?
If your Simrad GPS isn't updating its position, first check that the position mode is set to INTERNAL within the interface setup, accessible through [MENU], [6], [2], then Position. If the issue persists, consider replacing the antenna or cable.
What to do if Simrad GPS has no normal picture or key operation?
If your Simrad GPS shows no normal picture or key operation, try turning the unit off and on again. If that doesn't work, disconnect the power and reconnect it. Also, remove the C-MAP chart if you suspect it's defective. You can also return to factory presets.
How to fix a Simrad GPS screen that is too dark or too bright?
If the image on your Simrad GPS display screen is too dark or too bright, press [PWR], adjust the light, and then press [ENT].
What to do if all data is deleted after turning off the Simrad CP34 GPS?
If all data is deleted after turning off your Simrad GPS and turning it back on, the internal battery likely needs to be replaced by an authorized dealer. The expected lifetime of the battery is a minimum of 5 years.
General
