CR40/42/50 MKII Installation manual Chapter 9
136
Center
140
140
12
φ×
5
Measurements = mm
60
Forward
(5.51 in.)
(2.36 in.)
(0.47 in.)
30
(1.18 in.)
For air tube
(5.51 in.)
RB714 Radome scanner
• 45cm radome
• 2kW
• Range up to 24nm
• Rotation speed 24rpm
• Beamwidth: Horizontal 5.9°
Vertical 25°
The bolts included with your radar
equipment will suffice for mount
base thickness of 9 to 14mm (0.35 to
0.55 in.). If the mount base is thicker
or thinner than this, prepare bolts as
listed on the previous page.
Silicone should be applied to secure
the bolts. Do not use locking putty,
as it may damage the radome.
Drilling template for RB714A.
Fix four bolts
Mounting base
Washer
Spring washer
M10 Hexagonal bolt
Radome (bottom)
Chassis
Included
448 mm (17.9”)
220 mm
To Next Page
Loading...
