CR40/42/50 MKII Installation manual Chapter 9
137
RB715A Radome scanner
• 65cm radome
• 4kW
• Range up to 36nm
• Rotationspeed24or48rpm
• Beamwidth: Horizontal 3.9°
Vertical 25°
The bolts included with your radar
equipment will suffice for mount base
thickness of 9 to 14mm (0.35 to 0.55
in.). If the mount base is thicker or
thinner than this, prepare bolts as listed
on the previous page.
Silicone should be applied to secure the
bolts. Do not use locking putty, as it may
damage the radome.
Drilling template for RB715A.
Fix four screws
Mounting base
Washer
Spring washer
M10 Hexagonal bolt
Radome (bottom)
Chassis
Included
660 mm (26.4”)
255 mm
To Next Page
Loading...
