USB connector details
Unit socket (female)
The unit is equipped with standard USB type-A connector(s).
Video in
The unit can be connected to two composite video sources, and display video images on its
display.
Ú
Note: Camera cables are not supplied, and will need to be selected to suit termination -
BNC at the unit, and typically BNC or RCA plug at the camera end.
Ú
Note: The video images will not be shared with another unit via the network. It is only
possible to view video on the unit connected to the video source.
Ú
Note: Both NTSC and PAL formats are supported.
Video in connector details
Unit socket (female)
Pin Purpose
1 Ground
2 Signal
Video input configuration
Configurations to video input are made in the video panel. Refer to the Operator Manual for
more information.
HDMI out
The HDMI port(s) is used for connecting monitor(s).
The connected monitor should support the resolution listed in the Technical specifications,
or be able to scale.
Ú
Note: Some HDMI TV displays may apply over-scan, which will in effect crop the image
possibly causing loss of important content. Check the display manual for an option to
disable over-scan or adjust scaling.
HDMI connector details
Unit socket (female)
The unit is equipped with standard HDMI (Type A) connector(s).
Wiring | NSO evo3S MPU Installation Manual
To Next Page
Loading...
