EasyManuals Logo

Simrad RS40-B User Manual

Simrad RS40-B
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
| 5
| RS40/RS40-B User Guide
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that of the receiver is connected.
Consult the dealer or an experienced technician for help.
RF Exposure Compliance Statement for Handset
This device was tested for typical body-worn operations. To comply
with RF exposure requirements, a minimum separation distance of
0 mm must be maintained between the users body and the
handset, including the antenna.
FCC Part 18 Compliance Statement for Cradle Charger (BC-12)
This device complies with Part 18 of the FCC Rules.
CAUTION: Changes or modifications not expressly approved by the
party responsible for compliance could void the users authority to
operate the product.
¼ Note: This equipment has been tested and found to comply with
the limits for a wireless power transfer, pursuant to Part 18 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that of the receiver is connected.
Consult the dealer or an experienced technician for help.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simrad RS40-B and is the answer not in the manual?

Simrad RS40-B Specifications

General IconGeneral
BrandSimrad
ModelRS40-B
CategoryRadio
LanguageEnglish

Related product manuals