50 |
Wireless handset | RS40/RS40-B User Guide
Wireless handset
This radio can operate with up to two optional HS40 wireless
handsets. When a wireless handset is successfully ‘paired’ to the
radio, the buttons and screens on each device will be mirrored.
¼ Notes:
• The HS40 must be paired to the RS40/RS40-B base station radio
before it can be used. See “Pair a handset” on page 37 on how to
pair the wireless handset to the RS40/RS40-B.
• Maximum of two handsets can be paired with the RS40/RS40-B.
Using the wireless handset
Once the HS40 handset has been paired to the RS40/RS40-B, the
screen and button functionality are mimicked on each device.
Most functions that are provided on the RS40/RS40-B can be
accessed by the HS40 with the following exceptions:
• SETUP: Some setup functions are not available on the HS40.
• HAILER: It is not possible to enter HAILER mode from the HS40.
When the HS40 is not in use, it should be placed back into the
charger cradle. The HS40 is charged when placed in the cradle via
the built-in contactless inductive charging system.
Long press the X button to turn the wireless handset on. The
handset will display the software version and then attempt to
re-connect with the base station radio. Once connected use the
wireless handset in the same way as you would be using the base
station radio.
Long press the X button to turn the wireless handset Off.
The handset will automatically turn off after 90 seconds of no
communication with the base radio.
Using the Intercom facility
The Intercom mode works only when one or two optional HS40
handset(s) are installed.
1. Long press the AIS/IC key and select INTERCOM.
2. Press PTT to talk to the base station (and other handset if installed).
Release PTT to hear a reply.
3. Press X to quit the INTERCOM mode.
6
To Next Page
Loading...
Need help?
General
