Simrad RS90 - RS90 Transceiver

To Next Page

To Previous Page

| 13

Preparation | RS90 Installation Manual

Transceiver

• RS90 transceiver unit

• 2 m power supply cable

• 8-pin terminal connector x4

• 2-pin terminal connector x2

• Spare10Afuse

• Transceiver fasteners:

• M3.5 mm x 23 mm self-tapping screw x4

• M3.5 x 28 mm machine screw x4

• M3.5 nut x4

• Flat washer x4

External speaker unit

• External speaker (with 5m cable)

• Foam gasket (for ﬂush mounting)

• Plastic speaker surface mount box

• Speaker fasteners:

• M3 x 40 mm self-tapping screw x4

• M3 x 10 mm self-tapping screw x4

• M3 x 10 mm machine screw x4

• M3 x 40 mm machine screw x4

• M3 nut x8

• Spring washer x8

• Flat washer x8

Documentation

• Operating Manual

• Installation Manual

• Warranty Card

• DSC Warning Label

• Declaration of Conformity document (where applicable)

¼ Note: AVHFantennaisnotprovidedbySimrad.Anantennawith

a PL259 plug is required. Consult your Simrad dealer for advice if

required.

Other manuals for Simrad RS90