Simrad RS90 - System Overview; Introduction

12 |
Preparation | RS90 Installation Manual
Preparation
Caution: Under extreme operating conditions, the
temperature of the rear heat-sink on this radio may
reach a surface temperature that is unsafe to touch.
Caution is advised to prevent possible skin burns.
¼ Note: You must obtain a Maritime Mobile Service Identity (MMSI)
for the vessel before you can use the Digital Selective Calling (DSC)
function of this radio. Consult your local maritime authority or radio
spectrum authority to obtain your MMSI.
Checklist
The following items are included in the RS90 radio package:
Wired handset
• HS90 wired handset with cradle
• 5 m handset connector cable, including mid-cable connector.
• Mounting bracket for optional extension cable
• Silicon cover for cable connector
• Handset fasteners:
• 3.5 mm x 15 mm self-tapping screw x2 (cable mounting
bracket)
• 3.5 mm x 10 mm self-tapping screw x2
• 3 mm x 40 mm self-tapping screw x1
• M3.5 x 28 mm machine screw x2
• M3.0 x 40 mm machine screw x1
• M3.5 nut x2
• M3.0 nut x1
• Spring washer x2
• Flat washer x2
• Spring washer x1
• Flat washer x1
3