26 |
Installation | RS90 Installation Manual
Setting up the radio
¼ Note: You must enter your User MMSI before the DSC functions of
this radio will work.
See the Setup section in the RS90 Operating Manual for full setup
details.
NMEA 2000 Network
The radio can be connected to an NMEA 2000 network using an
NMEA 2000 compliant cable (not supplied).
1 Simrad chart plotter or MFD
2 GPS antenna
3 12 VDC supply
4 NMEA 2000 backbone with termination
5 VHF antenna
6 RS90 VHF radio transceiver
¼ Notes
• The NMEA backbone must be terminated at each end.
• The ‘drop’ cable to each device must not exceed 6 m.
• Further information on NMEA 2000 is available on the Simrad
website.
To Next Page
Loading...
Need help?
General
