Simrad Shipmate GN30 mkII - Page 17

$RAWLINE
To draw lines or to make a route is the same procedure,
please refer to above point 3.
0LOTTARGET
Plot and save the cursor position as a special target po-
sition. You will receive a display ’Set up target’ where
it is possible to alter the position or insert a location
name on the target position.
"EARINGANDDISTFROM!TO"
You can quickly obtain bearing and distance between
two points. Place cursor on the first position (A) and
press [PLOT], then place cursor on second position (B).
Bearing and distance will now be calculated from posi-
tion A to B, and the data will be shown in a small info
window.
$ISTAND44'INROUTEFROM!TO"
Navigational information from one route point to
another is easily obtained by placing the cursor on the
first route point (A) and press [ENT], then move to the
second route point (B) and press [ENT]. This will acti-
vate the ’Route calculation’ display, which will inform
of Total distance from A to B, Time to go from A to B,
Arrival time, etc.
'.-+))#HARTANDPOSITIONMENUS #HAPTER
17