Simrad Shipmate GN30 mkII - Page 16

0,/4FUNCTION
Press the [PLOT] key with chart in display, to call up an
info window with the following to choose from:
F Cursor must be active, otherwise it will be the ship’s
position which is plotted.
0LOTMARK
Plot and save the cursor position as a waypoint.
0LOTMARKWITHNAMEETC
Plot and save the cursor position as a waypoint, toggle
between LAT/LON, Loran C and decca lanes, insert a
location name or change the symbol on the waypoint.
-AKEROUTE
You can quickly make a route by plotting the cursor’s
position, one after another i.e. place the cursor on the
first position of the route you wish to make and press
[PLOT]. Move the cursor to the next position and press
[PLOT]. Continue in this manner till the route is com-
plete. In case you make a wrong plot, press [CLR] to
erase the last plotted position. Save the route with
[ENT] or exit the function with [MENU] to abandon the
route.
PLOT
Select PLOT mode
0LOTMARK
2:Plot mark with name etc.
3:Make route
4:Draw line
5:Plot target
6:Bearing and dist from A to B
7:Dist and TTG in route from A to B
Exit: MENU
#HAPTER '.-+))#HARTANDPOSITIONMENUS
16