To Next Page
A
ashleyrobertJul 27, 2025
What to do if Simrad TP10 loses course and goes into Standby mode?
- QqhollowayJul 27, 2025
If your Simrad Marine Equipment suddenly loses course and goes into Standby mode, it could be due to a few reasons. The power might have been interrupted briefly, or the voltage is low, so uprate batteries. It could also be that the cable used to the socket is too small, or that there is an intermittent connection. Check all connections and charge batteries. To resolve this, increase the size of the cable.
General
