Simrad V5043 - Ethernet Setting

51
Ethernet Setting
The default IP address and Mask is 192.168.0.100/24. Input groups NAVD, TGTD and SATD are always
enabled.
In this submenu the following Ethernet settings can be congured:
• IP address and network mask of AIS transceiver. Valid IP address ranges are shown as below:
10.0.0.0 ~ 10.255.255.255 (10/8 prex)
172.16.0.0 ~ 172.31.255.255 (172.16/12 prex)
192.168.0.0 ~ 192.168.255.255 (192.168/16 prex)
• SFI (System Function ID) of AIS transceiver — SFI Range for AIS is AI0000 ~ AI9999.
If SFI is AI9999 (default), V5043 will not send data to Ethernet.
• Additional input multicast group — This setting is used for additional input groups.
• Transmission group
• SFI for Primary position sensor
• SFI for Secondary position sensor
• SFI for Primary SOG/COG sensor
• SFI for Secondary SOG/COG sensor
• SFI for Primary heading sensor
• SFI for Secondary heading sensor
• SFI for Primary ROT sensor
• SFI for Secondary ROT sensor
• SFI for Primary AIS Control
• SFI for Secondary AIS Control
• SFI for Primary alert command source
• SFI for Secondary alert command source