Sinclair SIH-09BIK2 - Page 68

64
Installation and Maintenance
Service Manual
Main board
Wiring terminal
of motor
Wiring terminal
of stepping motor
Step Procedure
7.Remove evaporator assy
a
b
c
d
Remove 3 screws xing evaporator assy.
At the back of the unit, Loosen the clasp,connection
pipe clamp and then remove the connection pipe
clamp.
First remove the left side of evaporator from the groove
of bottom shell and then remove the right side from the
clasp on the bottom shell.
Adjust the position of connection pipe on evaporator
slightly and then lift the evaporator upwards to remove
it.
Screw
Connection pipe clamp
Clasp
Groove
Rear Case assy
Evaporator assy
Connection pipe