Singer 14U 34B - How to Thread Your Machine Correctly

• How to thread your machine correctly
Correct sewing cannot be obtained when machine is threaded incorrectly.
Threading is diagrammed on the inner side of the looper cover and identified with colors on the various
thread guides.
(1) Open looper cover. Thread the right looper in the order (T) to (8) as indicated in the figure below,
(threading points marked in orange)
While holding thread with finger, pass it
between the tension discs and pull thread
down to make certain it is properly located
in between the tension discs.
• Use tweezers provided in the accessory set when
threading looper thread hole (8).
• Draw about 5cm (2 inches) of thread from the
looper thread hole.
5