Singer 201P - Page 24

When tension has been correctly set for
average sewing, note’ number at indi-
cator line Z. This setting may be
quickly regained should the tension be
altered for special work or a change in
size of thread.
In the unbalanced tensions shown at top
of Fig. 23 caused by too heavy tension
on needle thread, the needle thread lies
straight along top side of material.
<_
—>
In the unbalanced tensions shown at
top of Fig. 24, caused by too light ten-
sion on needle ries | the bobbin
thread lies straight along under side of
material.
[f perfect stitching cannot be obtained
by regulating the needle thread tension,
check for minimum tension at ‘‘0"
position and if necessary adjust as in-
structed on page 27. Then regulate
bobbin thread tension as instructed on
pages 24 and 25.