Singer 201P - Gathering Foot; Shirring with Gathering Foot

To Adjust Ruffler for Group Pleating
1.
To make the space between groups of
pleats, raise adjusting lever E and
move it until projection D can be
entered in small slot indicated by
star on adjusting lever E. The ruffler
will then stop pleating and plain
stitching will be made.
loge,
N:
Ree
D>,
4
Vy
£26526
Fig. 64. Group Pleating with Ruffler
56
&2/0658
Fig. 65.Correct Position for Material
2. When the desired space is made, set
projection D in either of slots 6 or 12.
3. Insert material to be pleated between
two blue blades Line 2, Fig. 65.
GATHERING FOOT
To Shirr with Gathering Foot
1. Fasten gathering foot to presser bar
in place of presser foot.
Nm
Place material under gathering foot
and stitch in usual way.