Singer 201P - Ruffler for Group Pleating; Group Pleating with Ruffler

and insert it in ruffler, following
Line 6, Fig. 60.
To Adjust Ruffler for Pleating
1. Raise adjusting lever E and move it
until projection D can be entered in
slot marked *6" The ruffler will
then pleat once every six stitches. To
pleat once every 12 stitches, have
projection D enter slot ‘'12"’ in ad-
justing lever E.
2. Insert material to be pleated between
two blue blades Line 2, Fig. 62.
Fig. 62. Correct Position for Material
55
. To increase width of pleat, move ad-
justing finger F back toward needle
and turn adjusting screw C down-
ward. To make a smaller pleat, turn
adjusting screw C upward. The dis-
tance between pleats is regulated by
length of stitch.
Fig. 63. Pleating with the Ruffler