Singer 201P - Page 33

foot. Turn machine back on its hinges
and turn thumb screw P2, Fig. 28,
page 30 out of upper hole B, Fig. 28
in feed lifting crank Q2, Fig. 28, and
into lower hole A, Fig. 28. Make sure
that thumb screw is firmly tightened.
Bring machine forward into place, re-
turn stitch regulating lever W, Fig. 20,
page 18, to its original position and
the machine is ready for regular stitch-
ing. Stockings and socks, underwear,
etc., can be more conveniently darned
on the machine with the SINGER*
DARNING and Embroidery Attach-
ment.
Embroidering:
Prepare the machine the same as for
darning as instructed on page 30.
32
Lace Embroidery:
For lace embroidery, 1.e. open work,
replace the regular presser foot with
spring foot 121094. For embroidery the
feed should be lowered and the work
handled as advised in the preceding
paragraph.