Singer 201P - Binder Operation and Adjustment; Inserting Garment and Adjusting Binder

To Attach the Binder
Raise needle to its highest position.
Then attach binder to presser bar in
place of presser foot.
See that needle enters centre of needle
hole.
To Insert Binding in Binder
Cut all binding to a long point to the
left, as shown in Fig. 47A.
Folded bias bind-
ing must be in-
serted in the out-
side slot of the
scroll See Fig.
47B.
Unfolded or raw
edge bias binding
must be inserted
in the open end of
the scroll. See Fig.
47C.
Fig. 47C. Inserting Unfolded Bias Binding
After inserting pointed end of binding
in binder, push it through until full
width of binding is under needle.
46