Singer 4671 - Important Safety Precautions; General Safety Guidelines; Electrical Connection and Wiring

IMPORTANT
SAFEGUARDS
1 Remove plug
from the socket outlet when changing needles,
feet, or needle
plates, or when leaving
the machine unattended. This eliminates the
possibility of starting the machine by accidentally pressing the speed
controller
2. Before removing the bobbin case, remove plug from the socket outlet
3. Because
of the up and down movement of the needle, you must
work
carefully and watch the sewing area when operating the rhachine,
4. Do not pull the fabric while you are stitching as this may deflect the needle,
causing it to break.
5, Before cleaning your machine, remove plug from the socket outlet.
6. Do not attempt to adjust the motor belt. Contact your
nearest Service
Center should any adjustment be
required.
7. Before changing light bulb, make sure you have removed plug from socket
Cutlet, Be sure to replace the face plate which covers the light bulb before
operating the machine.
8 This machine is designed to use a 15-watt maximum light bulb.
9. This machine is double insulated When servicing, use only identical
replacement
parts
This product is suppressed
for radio an,d televis,on interference with the International
Efectro-technical Commission requirements of the CISPR
Machines for Great Britain and some other countries
having similar wiring standards
are shipped trom the factory wtthout a plug
for connection to the mains The wires
in this mains lead are coloured
in accordance with the following code.
Blue neutral (N) Brown live (L)
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked
with the letter N or coloured black, The wire which is coloured brown must be connected
to the terminal which is marked with the letler L or coloured red, If a 13 Amp. (BS
1363) plug is used. a 3 Amp. fuse must be fitted, or it any other type of plug is used
a 5 Amp fuse must be ftted either in the plug or adaptor or at the distribution boardl
Neither core is to be connected to the earth terminal of a three-pin plug