Singer 645 - Winding the Bobbin

WINDING
BOBBIN
Disengage
the hand
wheel
(1) from
the
stitching
mechanism by turning
the clutch nut
(2)
toward
you or
counter-clockwise.
Place
a
spool of thread
on one
of
the spool
pins
and lead thread
through
the rear
Top Thread Guide
(3)
after
winding
around
Bobbin,
Winder Tension Disc.
Run
the
end
of thread through
a
hole in
the
bobbin
edge and
place
bobbin on spindle of bobbin
winder
(4)
fitting
the
notch
on bobbin over
small spring on
spindle.
Push
bobbin winder latch (4), and
hold the thread
erd
loosely then
start
machine
slowly, and bobbin
winder
latch will be released
to
stop
winding when bobbin is full.
Turn clutch nut away
from
you
until
sewing
mechanism is again
engaged so that needle
moves
when
you turn the
hand
wheel.
Break
off loose thread end used
to
start the winding
and
cut other
thread
end.
Then
remove
bobbin
from bobbin winder.
F
_
‘A
- _z_