Singer 645 - Binder; Folded Binding; Two-Tone Binding; Hand-Cut Bias Binding

BINDER
This attachment
folds
bias binding
and applies it
to the
edge
of
material in one
operation.
Slots
on
scroll of the binder
are
for corres
ponding widths of commercially
folded
bias binding.
The
open mouth
of
binder scroll
is
used
for unfolded
bias
strips
cut
15-16 inch wide.
FOLDED
BINDING
Cut folded
binding
to a
point,
insert
in
appropriate
slot. Draw
through slot
and under
binder
with
strong pin.
Test stitching
to
be sure
it
is
on
the edge. Adjust
by sliding
binder
to
right or
left.
TWO-TONE
BINDING
Two bindings can be sewn
on fabric
edge also in one
operation. When
two are used always
skip one
size
between
widths, inserting
each
in
correct
size slot.
44
Cut
15-16
inch
bias
binding
fold
in
half
for a couple
of
inches.
Cut
binding
diagonally
toward
end,
almost to fold. Slip
fold
into
center
of binder.
Draw
back
until
cut
opens and
binding
encircles
open
end of
scroll. Test
stitching
to
be
sure
it is
on the
edge,
adjust
if
necessary.
See
suggestions on
how
to use
the
binder. There
are
hundreds
of
other
uses.
S
HAND-CUT
BIAS
BINDING
I