Class 99 & 99K
THE BIAS GAUGE
The Bias Gauge is very useful
(especially in the case of soft materials)
when cutting bias strips from 7/16 inch
to 1-3/8 inches in width. This is done
by placing the bias gauge upon the
point of the scissors and setting the
blued indicator to the width desired.
The line F is the point at which to set
the blued indicator for facings, the line
B for bindings, and the line C for
cording or piping.
Insert The material in the gauge with
the edge against the blued indicator,
and hold as shown at right.
Bias binding should be cut 15/16 inch
wide, and to do this the indicator should
be set midway between the lines F and
B.
Page 49
Table of Contents | Previous Page | Next Page
To Next Page
Loading...
