Class 99 & 99K
If the Machine is Electrically
Operated
Raise presser foot Q by means of
presser bar lifter R to prevent injury to
the foot Q and feed T.
Place a piece of material under presser
foot and let the foot down upon it. Turn
on electric current and, if the
combination knee and foot controller is
installed as a knee controller, press
knee lever to the right. If controller is
placed on the floor to be used as a foot
controller, press down on pedal of
controller. The speed of the machine is
controlled entirely by the amount of
presser applied to the controller.
Operate machine in this way, without
being threaded, until you have become
accustomed to guiding the material and
operating the controller.
Page 5
Table of Contents | Previous Page | Next Page
To Next Page
Loading...
