the manufacturer. If an additional device is
installed on the platform or guardrail for placing
tools or other materials, this will increase the
platform weight and surface area or increase the
load.
Do not place or attach any suspended load on
any part of the machine.
Do not put ladders or scaffolding within the
platform or any part near the machine.
Do not use the machine on any mobile or
movable surface or vehicl
e. Ensure that all the
tires are in good conditions and the slotted nuts
have been tightened and the cotter pins are
complete.
Do not use the storage battery with weight
lighter than that of the original one. The storage
battery not only provides power but also serves
as balance weight, which is vital to the machine
stability.
For: GJZ0608, GTJZ0808, GTJZ0612,
GTJZ0812, GTJZ1012
The weight of each storage battery must reach
28kg.
For GTJZ1212
The weight of each storage battery must reach
33kg.
Do not use the machine as a crane.
Do not push the machine or other objects with
the platform.
Do not let the platform touch the adjacent
object.
Do not bind the platform on the adjacent object.
Do not put the load outside the platform.
Do not operate the machine when the left and
right side doors are opened.
Do not lower the platform with the pl
atform
controller when the platform gets caught or
stuck, or is obstructed by other objects to move
normally. Operate only after all personnel leave
the platform if intending to lower the platform
with the ground controller.
Hazard of Falling
The personnel on the
platform must wear seat
belts or use safety
facilities that comply
with government
regulations. Tie the
lanyard to the fixed
point of the platform.
Do not sit, stand or crawl on the platform guard
railing. Stand on the platform floor stably at all
times.
Do not climb down from the platform when it is
raised.
Keep the platform floor free from obstacles.
Do not enter or exit the platform unless the
machine is in the fully retracted position.
Close the entrance door before operating.
11
GTJZ0608 & GTJZ0808 & GTJZ1012 & GTJZ1212 & GTJZ0612 & GTJZ0812 Operation Manual
To Next Page
Loading...
