6
4.5. Take off Alarm setting (Factory default setting is on.)
Command：TAKEOFF0000 1
Message Reply: SET OK!
Not
e: There is anti-removal induction sensor on the back of device. If
this covered induction sensor is not covered again. It will send “Take
off Alarms!” to admin number and SOS number by SMS.
Take off Alarm Canceling:
Command: TAKEOFF0000 0
Reply: SET OK!
4.6. Device working mode setting
1. WORK-Keep working mode: (7 days per 10000mAh)
Command: WORK0000
Reply: SET OK!
(The tracker will keep working and send data by time interval)
2. MOVE-Work when the tracker is moving: (30 days per 10000mAh)
Command: MOVE0000
Reply: SET OK!
(Factory setting is “MOVE” mode)
(Tracker only works when it is moving, when it is stopped, it will sleep,
GPS shut off, GSM works in low consumption mode. Vibration, SMS
command, calling tracker can wake up the tracker to work 5 minutes.)
3. STANDBY-SMS or Call to tracker, it will work 5 minutes.
(120days per 10000mAh)
Command: STANDBY0000
Reply: SET OK!
(Standby mode, GPS shut off, GSM works in low consumption. SMS,
calling can wake up the tracker to work 5 minutes.)
To Next Page
Loading...
