3
1. INTRODUCTION
This manual describes how to install and use SINTROL digital
triboelectric dust emission monitors S304 and S305.
Sintrol shall not be held liable for any loss or damage whatsoever arising
from omissions or errors in this manual, or any misuse of the product.
1.1 Safety
Model LV requires a 115 VAC, 50/60 Hz power supply and model HV a 230
VAC, 50/60 Hz power supply. In both cases, the power supply must be
considered as potentially lethal and all suitable precautions must be taken
whenever the cover of the unit is removed.
S300 Series dust monitors are virtually maintenance free. Under no
circumstances should the user attempt to replace any components or the PC
board. If, for some reason the monitor fails to operate, contact your local
distributor or the manufacturer.
Take appropriate precautions when installing the monitor:
Unless the process conditions are known to be entirely safe,
suitable precautions must be taken before any entry is made into
the duct for installation or maintenance purposes.
The unit may be installed in ducting, containing particulate, hazardous to
health.
The particulate may be inflammable, explosive or toxic
The gas can be hot and pressurised
The S300 Series dust monitors do not have an internal circuit breaker. The
customer has to install a separate circuit breaker to the power cable to ensure
that the power can be isolated. Electrical installations must be carried out in a
manner to satisfy all applicable, local regulations.
It is essential that the unit is correctly grounded!
(see section 3.1)
To Next Page
Loading...
