SINUS Tango Plus - Manual Configuration; Tango-Utilities

2.3 Tango-Utilities
2.2.2 Manual configuration
The manual configuration of the device without PC is shown in the following table 2.2:
Item Description
Measurement
Record Mode Select values to be stored or just displayed.
Sync at Full Hour Synchronize time intervals to full hours.
Calibration
Start Calibration Start the process of calibration.
Calibration Level Set the calibration level.
Measurement Values (Select a sound level e.g. L
AFmax
and adjust the following properties.)
Display Location Select on which graph the value shall be shown.
Display Interval Select the rate of display refresh (500 ms, . . . , 60 min, End Result only).
Storage Interval Set the storage interval (No storage, 500 ms, . . . , 60 min, End Result only).
Print Result Decide whether the result shall be printed.
Octave Spectra
Octave Mode Select whether 1/3 or full octaves shall be measured.
Frequency Weigthing Available weigthings: Z, A, C
Display Range Adjust the scaling of the Y-axis.
Display Interval Select the rate of display refresh (125 ms, . . . , 60 min, End Result only).
Storage Interval Set the storage interval (No storage, 125 ms, . . . , 60 min, End Result only).
Storage Weigthing Available weigthings: Z, A, C
History Graph
Display Range Adjust the scaling of the Y-axis.
History Time Adjust the scaling of the X-axis.
Graph 1 Select which value shall be displayed as yellow.
Graph 2 Select which value shall be displayed as green.
Device
Time Set time and select 12h or 24h format.
Display Set Display properties.
Info Read off version numbers of firmware and hardware.
Print Results
Table 2.2: Manual configuration menu of Tango_Plus
2.3 Tango-Utilities
Tango-Utilities is the basic software to configure Tango_Plus and export values from measurements. It is
not meant to perform further analysis calculations.
Status bar
The status bar displays various status information from left to right:
Connection Status: disconnected, connected, but Tango_Plus off, connected, Tango_Plus on;
Virtual COM Port;
Measurement Status: Stop, Measurement, Pause;
Record Status: Record-Mode off, Record-Mode on,
blinken
←→ Record-Mode on (Recording);
Marker Status: MARK;
Memory usage: per Hour, Day and Week
SINUS Messtechnik GmbH 13 of 30 Manual Tango_Plus