2.3 Tango-Utilities
In the Octave tab spectral values are shown (figure 2.7), which are calculated by the device during a mea-
surement (according to the settings in the Setup-Tab). To adjust weigthing (Z-blue, A-green, C-yellow) or
refresh rate for graphical display click on the corresponding items in the header of the graph. The context
menu of the graph provides scaling functionality. Also displayed is a coordinate cross. The vertical line
shows the current value of the selected band while the horizontal line shows the sum value.
2.3.5 Data-Tab
On the right side of the Data-Tab (figure 2.8) a table containing the recorded files is displayed. On the left
side a summary of the selected measurement is displayed. By right-clicking on an entry in the table you will
open a context menu in which you may delete the measurement (Delete) or save data to the PC (Export).
Figure 2.8: Export measurements in Data Tab
2.3.6 Data export
Measured data are saved to the internal storage of the device (32 MB). The data sets are listed in the
Data-Tab (section 2.3.5). By right-clicking you may open a context menu, that provides access to the Export
window (figure 2.9). It provides tabs for user defined metainformation, smr export for AUDITOR, txt export
(figure 2.10) for only end results as well as a tab for csv export (for excel) (figure 2.11).
The last tab include two lists. The left one shows the values which are part of the measurement, but which
have not been selected for export yet. The right list shows the values, which have been selected for export
already. To add or remove values from these lists use the buttons
Include
and
Exclude
. To add new files for
export use the button
Add File
, to remove files use
Remove File
.
SINUS Messtechnik GmbH 17 of 30 Manual Tango_Plus
To Next Page
Loading...
