2 APPLIANCE
Program settings and Extended device settings
Via the main menu Settings->Program. . . the following settings are available (figure 2.1): Selection of the
connected device Tango_Plus (Connected Device), default export directory (Default Export Directory)
and the default directory for configuration data. The Extended device settings cannot be adjusted manually
without PC.
Figure 2.1: Tango-Utilities - Program settings Figure 2.2: Tango-Utilities- Extended device settings
Parameter Description
Disable Device Calibration Select this parameter to disable calibration feature on the device.
Disable display setup changes Select this parameter to lock the display settings.
Disable measurement setup changes Select this parameter to lock measurement recording settings.
Enable fixed record mode Select this parameter to activate the Record-Mode permanently.
Startup after battery replacement Automatic start of Tango_Plus after changing the batteries.
Table 2.3: Extended progam settings
2.3.1 Info Tab
You may view the software version of Tango-Utilities in the main menu selecting Help -> About (figure 2.4).
The firmware version of the device is displayed in the Info-Tab (figure 2.3).
Figure 2.3: Tango-Utilities - Info Tab Figure 2.4: Tango-Utilities - About-Box
Manual Tango_Plus 14 of 30 SINUS Messtechnik GmbH
To Next Page
Loading...
